Interested to Buy Any Domain ? << Click Here >> for more details...
What happened when a three phase induction motor work on
two phase supply.9
- 6 Answers
- 9963 Views
- I also Faced
- E-Mail Answers
Answer Posted / nigam kumar singh
to meet the same load motor will draw additional current,
which can burn its winding ,so over current/overload
protection relay will trip the motor.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
if you are in a software company,then why do you want to come in a core company like sail, ntpc(where lots of trouble like tension but you have a good life in a it company) ?
hi I have done 3 yrs diploma in electrical engg after 10+2. I have 16 years of work experience into design proposals sales and engg application development in LV/MV swithcgear and sub station automation field. I want to apply for immigration to new zealand but I am not sure whether I qualify or not since I dont have a degree. Can anyone advice? Thanks Riz
WHAT IS THE PARTIAL DISCHARGE TEST?
What are reasond for high wattage in single phase induction motors
how the testing of protection CT Testing done through Primary injection kit please describe in detail procedure...
Which of the following alternatives will be cheaper (1) A 100 h.p AC, 3-phase motor (2) Four motors of 25 h.p each (3) Five motors of 20 h.p each (4) 10 motors of 10 h.p each explain
how can we change the polarity of Alternating current rapidly? how frequency of ac can be controlled and changed easily?
what happens to the water pump if ground water level is slowly decreasing?our water pump is varying from no-load full-load due to this problem
if the number of poles generated in stator and rotor side of an induction motor are different then what will happen and why?
Refernce currents are to be generated using refernce cueernts how can this be done??
what is the formula for computing cable tray size & capacity
Cables Construction hi friends, 0.6/1/1.2 kV LV , DC and Control cables are concentric copper conductor what does its means and what is the use of concentric copper conductor,and are this with copper tape shield or copper screening, ? thanks
I want to know the 'Test voltage' for Tandelta testing of 3.3 / 6.6 / 11 KV Motors. Please explain
For the requirement of a furnace of temperature range up to 1200 oC using silicon carbide rods, What is the required rate of transformer needed (please do it with all details)?
I AM A ELECTRICAL PANEL BOARD DESIGN ENGINEER.IF I GO ANY INTERVIEW ,TECHNICALLY WHAT ARE QUESTIONS I WILL FACE FROM INTERVIEWER?
