11 kv metering is done in my factory.Meter show PF 1.000
but kvarh lag&lead show 24&94 respectively & Avg.PF
is .956 .? is what i do for inproove my PF to 1.000
Answer Posted / prasad
If your metering cubicle is showing PF as unity then what
is the problem?
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
which is the best institute for PLC,SCADA,DCS in hyderabad
what is acceptable leakage current for 33kv cable while doing high voltage test for cable? how to calaulate the leakage current for 33kv or any rated cable?
What is the need for a controller?
PLEASE TELL ME ABOUT QUESTION PAPER OF UPCL ENTERENCE EXAM.
How cmd is calculated in case of energy neters
How to do maintenance of transformer feeder.
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
Which device of PlC does share load between DG sets when DG are running in perallel?
Define resonant peak?
What are Contactors? How they works and what its highest rating?
What is the differentional relay...what is the work of this in power Tx. how it is works..
what is settable hystersis protection? If any body knows plz kindly post the answer..
what is the difference between delta delta and star delta connection transformer? why we use delta delta transformer since it need earthing transformer for grounding?
How many gap between finger contact in a.c.b. and v.cb.?
any one can explain the stages of a knee point which is taken during ct magnetising curve.