Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / satya dev
As per IE Rule Below than 1000 Amp. Load we can use MCCB &
Above than 1000 Amp. Load we must be use ACB.another reason
is the Range of Short Ckt Capacity of ACB is Greater Than
the MCCB.
| Is This Answer Correct ? | 9 Yes | 4 No |
Post New Answer View All Answers
do you have some of interview Questions in power and genrator section in general whith answers
when the time of backcharging the transformer three phases only enough or three phase with neutral is must.from these which one is the best one.
What facility we get after CT secondary earthing and how?
If I have 3 essential main switch board and 3 incoming electricity ,but only 1 genset running is that possible.
I need bhel electrical test pattern & paper
How many energy meters can be connected on a 15VA Voltage transformer. please send a calculation sheet.
What are all present producing cost of Per KWH of various Fuel?
why can the rotor of 3 phase slip ring induction motor not be a 2 phase rotor?
Give two basic speed control scheme of dc shunt motor?
The slip during plugging operation is given by= A 1-s B 2+s C 1+s D 2-s
what is the use of commutator in dc motor if we supply ac ? commutator is used to convert ac to dc.and it is used to arrange the flux in unidirectional in case of dc supply. if we give ac as supply to dc motor what is the use of commutator?
What is “pu” in electrical engineering?
What are the factors influence the choice of an electrc drive?
following are the questions asked in interviews: 1) Considering the short circuit fault, which switchgear is preferable, SFU OR MCCB? Which operates faster? whicg one is popular in Indian Market and why? 2)Define SCPD. What is type2 coodination? 3)Why the contactor rating is higher for the fuseless selection than for fuse selection? whether the ratinf of SFU or MCCB remains the same in both the cases? 4)If the HP rating is known then can you calculate the ratings of L.V Switchgear(SFU/MCCB, contactor, OLR) without using the selection chart?
In diesel generator how AVR get voltage to excitation. And basic diagram DG EXCITATION CIRCUIT.
