If DC supply is given to a transformer it may
a) Work
b)Not Work
c)Give lower voltage than the rated voltage on secondary
side.
d)burn the winding
- 12 Answers
- 13330 Views
- wbsedcl, I also Faced
- E-Mail Answers
Answer Posted / baljinder singh
First of all ,when we give the dc supply to
transformer,flux set up around the winding or in core ,but
this flux is statoinary and not link with winding so there
is not produce the back emf .The resistence of primary is a
few ohm(1-5).According to ohm law I=V/R .
When voltage applied across ,the back emf is not
produce ,resistence is very low ,so heavy current flowing
throw it .The winding will burn.
| Is This Answer Correct ? | 17 Yes | 2 No |
Post New Answer View All Answers
Define ampere
what is the step by step formula for calculating bus bar phase and neutral size of a panel board.suppose the incomer of panel board is 100A..???step by step answer please
what is the correct method for the outdoor termination of 19/33 KV HT cable step by step?
WHAT R THE SAFETIES IN A HIGH TENSION PANEL N LOW TENSION PANEL. ALSO WAT SAFETIES R THERE IN A 200 KVA TRANSFORMER?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
why we use four type of phase angle difference between pimary & secondry winding of a transformer & where we use them?
What is kirchoff ’s current law (kcl)?
WHY NUTRAL GROUND SYSTEM USED IN 33KV SYSTEM
What current flows in the transformer primary when its secondary is open?
Cables Construction hi friends, 0.6/1/1.2 kV LV , DC and Control cables are concentric copper conductor what does its means and what is the use of concentric copper conductor,and are this with copper tape shield or copper screening, ? thanks
Why should we hire you over the others waiting to be interview?
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
what is the relation between size of the anteena and wavelenghth of radiated wave
What is acsr cable and where we use it?
What is the typical enclosure type used for Indoor switchgear / Outdoor switchgear Units? - In Onshore / offshore Units?
