If DC supply is given to a transformer it may
a) Work
b)Not Work
c)Give lower voltage than the rated voltage on secondary
side.
d)burn the winding
- 12 Answers
- 13344 Views
- wbsedcl, I also Faced
- E-Mail Answers
Answer Posted / biman mandal
d) Burn the winding
| Is This Answer Correct ? | 25 Yes | 6 No |
Post New Answer View All Answers
why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??
State nyquist stability criterion.
As we use capacitior bank in 3ph ckt for improvement of PF, why not we use capacitor in single phase domestric use, at our house their are many inductive equipments,like fan,mixer,tube choke,air conditioner they also draw PF... by using capacitor can they improve PF. if yes--what are advantage and how to connect a capactor in single ph,and which type of capacitor if no- what are disadvantages.
Why do we need a separate control desk & PLC control panel in Boiler plant or coal handling plant? Can we provide cost effective Control desk cum PLC panel. Is there is an specific need for control desk.. kindly advice.
Two bulbs of 100w and 40w respectively connected in series across a 230v supply which bulb will glow bright and why?
describe the A.C. Generator Testing procedure
Why do we pefer VCB over OCB?What are the advantages of VCB over OCB?
Benifits of 3ph 4 wire metering over 3ph 3 wire
How can we measure the residual voltage in dc machines?
Dear sir, In our plant have Station Transformer having capacity,i want to know, why LV side 40 - 40MVA is given? & how we can get 6.3 KV supply from tertiary(i.e. Open delta connection), Vector Group YNyn0 - yn0 +d MVA Rating 80MVA / 40 - 40MVA + 26.7MVA Voltage rating 420 (Tap range +6,to -10)81.25% /11.5KV - 11.5KV +6.3KV
Sir, I have applied for the of Jr.engineer(Electrical & Electronics) & ASST. LOCO PILOT at ALL RRB BOARDS. please send me all RRB Boards solved papers in the year of 2001 tO till date. i requested send me the papers to my id as soon as possible (jet_0991@yahoo.com). (This is very urgent) Thank You,
What is q factor?
How can we increase fuel-power ratio of any DG set?
What is mean by hot and cold loop testing? What is the difference between them?
what happen if the parallel generator phase angle shift by 1 degree in manual mode
