Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / raghavendran
MCB's have tripping curves like B,Cand D.
Curve B type of MCB's are used where maximum sensitivity is
needed and the initial starting current is 3 to 5 times the
rated current.
curve c MCB's are used where close protection is not
required and the starting current is 5 to 10 times the rated
current.these may be used while tripping the circuit due to
high starting inrush current.
curve D MCB's are used where the starting current is very
high 10 to 20 times the rated current, like high capacity
motor installation where initial starting voltage dip may be
very high.
| Is This Answer Correct ? | 98 Yes | 4 No |
Post New Answer View All Answers
how the testing of protection CT Testing done through Primary injection kit please describe in detail procedure...
What are the disadvantages of thermal power plant?
What is domestic transformer? Draw the connection of domestic transformer.
when will be the iocl interview results ifaced the interview on september 8 th
in a solar power plant,we are going to step up the voltage 350V to 33kv, and to 132kv GSS. i want to ask that if it is possible that 315v/33kv is not possible because we also use 315v/11kv. or it should be 415v/33kv? is it effects generation or losses? the second question is-generation is depends on LV winding? or LV winding design for generation voltage?
what is meant by poly phase induction motor ? how its operating by single phase or three phase?
how to calculation increase capacitor,increase power factor for three phase.
we have require a Motor (1500kW, 6.6kV, 50Hz) which shall operate at 1500rpm during 30min and after it shall run on 500rpm during 15min. The same cycle shall be repetitive during the whole working days. Which method is best and economic to achieve such type of task. VFD, VVFD, Pole changing motor etc.
how can we say that stator magnetic field rotates with synchronous speed?can we derive?
How to do cable earhing? whether by grounding Armour to ground or by running extra G.I wire along with cable? which one is preferred mostly amoung them? If the second one is more preferable how many GI wires to be run along with cable (1 or 2)?
what is meant by directional earth fault and non directional earth fault? describe both.
1. Design a counter which counts 0, 4, 8, 2, 6, and repeats using: 1.a using JK flip flops 1.b using T flip flops 1.c using D flip flops
I HAVE A 50A MCCB AS PER DESIGN LINE WIRE CONNECT UPWORD SIDE AND LOAD IS CONNECTED TO DOWNWARD SIDE TO THE MCCB.IF NOW ANY ONE CHANGE SUPPLY & LOAD(WISEVERSA) WHAT HAPPENS ? DOES MCCB OPERATION OR WORKING FUNCTION NORMAL IF YES THAN WHY THERE ARE MARKED LINE & LOAD ON MCCB.
how we select ac fuse rating of an power inverter???
How to Calculate the Fault Level of Electrical Installation
