What should be value of Circuit breaker operating time and
tripping time?
- 5 Answers
- 13124 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajesh kumar
circuit breaker closing time 40msec.
circuit breaker tripping time less than 20 msec.
| Is This Answer Correct ? | 4 Yes | 8 No |
Post New Answer View All Answers
I need a formula to calculate the size of cable as per load but in the terms of length. Please Reply me as i search lot of sites but i did not get the answer.
Can we check ELCB constantly from R1 to R8 phase in 1 no DB?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
When a square wave is applied to primary of a transformer then what will be output wave form of secondary ?
what happen if drive input fail momentry at 48.5 HZ frequency?
is it possible to start a motor in felid connected to a remote mcc
plz send me HPCL apptitude paper.. maulik_elect@yahoo.co.in
What is capacitance?
What is the purpose of using busbar mounting fuse?
some time we open engine breaker 8.0 MW load but plant not trip. and another time engine open 4.0 MW load engine trip why? individually engine breaker open & individually emergency stop why difference?
For a 6.6kV Motor it is recommended to do megger test with 500 V d.c and not more than 5kV d.c but the Hi voltage withstand test should be performed by 12kV AC. Why the dc voltage test should be limited but AC voltage withstand test could be with such a high voltage?
in an electronic tri vector meter when the current and voltage sequence changes ? what is the effect of phase sequence on recording of meter
WHAT IS MEANT BY TV TERMINAL IN 500MVA TRANSFORMER?
When calculating the speed of a rotor required for a particular frequency of synchronous generator we use the equation 60f/p Is this p is the number of pole pairs of rotor & do we consider the number of pole pairs in the stator is 1?
What is the difference between isolators and electrical circuit breakers?
