Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / kalaiselvan
flow directly proportional to square root of differential
pressure so we measure flow in square root
Q = SQARE ROOT OFF DIFFERENTIAL PRESSURE
| Is This Answer Correct ? | 13 Yes | 9 No |
Post New Answer View All Answers
what is use of communication wire in multipare cable(oil and gas field), why this communication wire not used in single pair cable?
Hi, Is there any smart plant instrumentation design training institute in Bangalore?
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
how to calibrate Necleuonic level transmitter.?
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
How r the calculation of process line mpm.
give me all the details about the interview and which type of question being asked
How many interlocks at turbine side?
how to calibrate load cell
Whatis the reset ofset and control system in instrumentation
selection of the zener barrier for the hazardeous area zone 0
Describe a time when you anticipated potential problems and developed preventive measures.
What is defferent betwen ESP &PCP PUMP .HOW IT IS WORK?
how to control pid
