Interested to Buy Any Domain ? << Click Here >> for more details...
what happen "when Dyn11 is parallel operation with Dyn1"?
- 9 Answers
- 18785 Views
- I also Faced
- E-Mail Answers
Answer Posted / akhilesh singh
Due to 60deg phasor diff., PD of two secondaries will
arise. Therefor a circulating current between these two
secondary flows which causes shortcircuiting.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
hi everybody how to design string combiner box (scb) internal parameters like bus bar and spd (surge protection device and fuse which place to set that,and also bus bar one particular cross sectional how much heat generated and how much power loss tell me Clearly and briefly
is it possible to have dc motors on single chip
Can we use Ccapacitive voltage transformer directly for metering purpose?
How to select HT/MV cable size ?
What is power factor why we should maintain the power factor unless what will happen
I want formula to calculate cable size as per load given in length & amp. I searched many sites but didn't right answer. Please reply me asap.
What is ST and specify its range of voltage.
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
In the N-series schneider reclosers. What is the difference between current during fault time and current at tripping? This appears in the Event log in an event of a trip out.
Name the component u would expect to find in a switchgear assembly?
What happens if the negative to earth voltage is greater than positive to earth voltage in the battery of substation?
How can a equal potential zone be carried out in conductors?
WANTCONTACT NUMBER & EMAIL/ WEBSITE TO CONTACT THE SECRETARY,MADHYA PRADESH LICENSING BOARD(ELECTRICAL),K- BLOCK,3RD FLOOR,SATPOODA BHAWAN,BHOPAL
what is the effect of higher value of GD???
what is the difference b/w absolute encoder and incremental encoder?
