Interested to Buy Any Domain ? << Click Here >> for more details...
I HAVE A 1 MVA TRANSFORMER, I WANT TO KNOW THE FAULT LEVEL OF
THE SYSTEM ( WHAT IS FAULT LEVEL PLEASE EXPLAIN WITH EXAMPLE)
- 5 Answers
- 23755 Views
- Alstom, I also Faced
- E-Mail Answers
Answer Posted / deepak gupta
above ans. is right
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
how slip power recovery system work
how to commissioning the genset with amf panel?
What are the effects of adding a zero to a system?
Can an inverter be used as a converter? How?
I am inpecting a 10kVA UPS what tests should i do and should i observe?
1600kva capacity Transformers how the bucholz relay,Oil temperature,winding,surge relay relays setting are to be done
how to avoid electrical shock how capacitor store charges wat are the speed control of induction motors state faradays law flemings left hand rule what is rotary converter wat is transmission and distribution what are the sources of energy abrevation of acb,vcb,sf6,igbt what is output equation of transformer which test copper iron and iron loss are calculated what is eddy current draw a single line diagram (10 marks) draw direct online starter(10 marks)
In between UPS out going changer over switch and ups raising main input, both side cable gland producing heat but the cable doesn't get heat,Why?
How to calculate no of EARTH PIT? Describe the formula as per IS standard?
can any one suggest paper presentation topies for electrical engg?
in dc suppy frequency is zero why? if dc frequency is zero how to exist dc transients and ac transients
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
What is ST and specify its range of voltage.
How to do cable earhing? whether by grounding Armour to ground or by running extra G.I wire along with cable? which one is preferred mostly amoung them? If the second one is more preferable how many GI wires to be run along with cable (1 or 2)?
Is there any specialised book to refer about fault level calculation both in MV and LV side??
