Interested to Buy Any Domain ? << Click Here >> for more details...
if 40 watt bulb has higher resistance then a 100watt bulb
then according to joul farmula p=I^2R the 40 watt bulb more
power consume then 100 watt bulb.
- 5 Answers
- 13937 Views
- I also Faced
- E-Mail Answers
Answer Posted / manda.gopal1
I think that 40 watt bulb has more impidence then 100 watt
bulb. 40 watt bulb offer higher impedence then 100 watt bulb
| Is This Answer Correct ? | 3 Yes | 12 No |
Post New Answer View All Answers
how to calculate the lightning arrester conductor @ no of earth pits required
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
why are the maintaine power factor and how can this control and this is how work.
I COMPLITED MY B.TECH AND 10TH CLASS WITH 70%MARKS BUT 12TH CLASS 55%MARKS..CAN I GET INDIAN RAILWAY RECUREMENT EXAMINATION?
What is a advantage of Self Reset Lockout ? On Fault breaker get trip & fault no longer exist then self reset lockout how inform us?
what is the effect of vector group while phase sequence of a generator changes,whether the vector group changes or not
when measure the core loss of three phase distribution transformer or three phase reactor loss, one phase shown negative watt loss. why??
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
High voltage test procedure of in swgr board. why should measure millivolt drop on testing time?
for what purpose the star point is done in ct
Why cables and busbar both needed in LT Panels?
what rectifiers is and what are the types of rectifiers?
Why is the air gap between the pole pieces and the armature kept very small?
What is the difference between AC and DC injection methods for rotor earth fault protection
How to determine the breaking capacity such as break down current and break down voltage for VCB and CT's.
