What is the Diference between DYN 11 and DYN 5 .How to
change the Vector group from DYN 11 to DYN 5.
Answer Posted / hemant dehariya
In DYN 11 & DYN 5 is DYN 11 is HV voltage is lead from LV by angle of 30 degree and in DYN 5 HV voltage leg fron LV voltage by 150 degree.we can change vector group from DYN 11 to DYN 5 by change primary winding connection of transformer.
| Is This Answer Correct ? | 21 Yes | 19 No |
Post New Answer View All Answers
What is phase cross over frequency?
why we cannot protect 100% winding of an alternator by using differential protection?
magnetizer priciple
What is open loop and control loop systems?
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
As a electrical engineer.. what are the basic norms should follow in transformer oil testing.. 1.What is the Electrode type? 2.How long time you will give for oil testing?
In Power cable specification what is U0/U and Um.
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
can any one tell in easy method for circulating current ??
can we conduct the swineburne's test on a dc series motor? why?
A Question Like A Wire Is Wound Whose Resistance Is Some 132. 44647 Ohms. If A Voltage Of 30 mv, 296 Ma Current Is Applied To It What Is The Resistance.
in a simple IDMT relay we use neutral point of ct for earth fault then what is the requirement of neutral ct and cbct?
sir, Is their any measuring unit of knoking? please explian?
what are the steps involved in generator load test?
what is difference between 9kv 5ka surge arrester and 9kv 10ka surge arrester.