In distribution transformers, fuse wires are very thin when
compared to conductor size. How it's possible?
Answer Posted / kanwaljeet singh
U might need to check again, some uneducated technician
would have installed the thin wire. Replace it immediately
and confirm me and dont repeat such mistakes.
| Is This Answer Correct ? | 0 Yes | 12 No |
Post New Answer View All Answers
what happen if the parallel generator phase angle shift by 1 degree in manual mode
What are approaches to tackle sedimentation problem of reservoir?
According to IEC60034-14, When the vibration monitoring system required for motor Bearing. above which KW, it is required? and for what type of bearing the vibration probe is provided.
what is smartµ grid technology?under coal gassification?
which type of stability limit is higher,steady state or transient? why?
what are the sample questions asking to the test cunducting for electrical superwising lisence test?
what is two point starter?
why impedance relay is used for medium transmission line protection
What is the necessary condition for stability.
A 50Hz,4-pole,3-phase,star-connected synchronous motor has a synchronous reactance of 12ohmsper phase and negligible armature resistances.the excitation is such as to give an open-circuit voltage of 13.2kilovolt.the motor is connected to 115kilovolt, 50hertz supplying. what maximum load can be the motor torque,line current and power factor?
If we impress a dc voltage of 230 V on an unloaded 230 V, 50 Hz transformer it wi A give high secondary voltage B burn out C give secondary voltage as per K D none of these
Why frame of the motor is specified?. If we mention KW and voltage level,automatically frame is decided or separately frame is compulsory to mention?.
what is the difference between dry and wet type of 132kV terminations. which one is durable
what is the difference between droop mode and ischnorous mode in thermal powerplant?
what is KSR type transmission tower? What is LSR type transmission tower?