Interested to Buy Any Domain ? << Click Here >> for more details...
how to check the 3ph capacitor is good or not.
- 14 Answers
- 59485 Views
- MacLellan, Yash Technologies, I also Faced
- E-Mail Answers
Answer Posted / uk
Disconnect the capacitor from the supply and test the
capacitor terminals with a volt meter, you should have the
same voltage at these terminals as the supply voltage the
capacitor was connected to (you should probably not leave
it too long before you test the capacitor as some
capacitors tend to discharge b y themselves over time).
or you can discharge the capacitor by shorting the
terminals WITH A RESISTIVE LOAD you should never short out
a capacitor with that sort of voltage, it will be
danegerous, by using a resistive load, it will take longer
but it will be safer at least.
once you have discharged the capacitor, most decent
multimeters will have a capacitive test function, just test
the capacitor at the terminals and compare the value with
the value written on the side of the capacitpr and this
will also give you an indication of the its condition..
otherwise, call an electrician...
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
Give the expression for the frequency of oscillations in an op-amp sine wave oscillator?
How to calculate the no of Ceiling fan (1200mm sweep) per unit area?
one electromagnet is called
how meger function
how to test the electrical panel.ht lt mcc pcc.
Can 4pole (3 phase+neautral )RCCB proper functioning in only 3 phase load (no neautral, no Earth) ?
what is thermal resistance of PVC Cable.
Why does the adjacent zone of protection overlap?
what kinds of Transformer oil grade is better for power transformer ?
armature winding of dc machine produce alternating emf then it convert in to dc by using commutator.But only we consider armature resistance why don't we consider inductive reactane effect?
induction 3 phase motor terminal connection
what is kvarh? Please define it With calculation General motors ?
State magnitude criterion.
In what cases (circumstances)we should apply P controller, PD controller, PI controller & PID controller ?
What are the specifications for conducting earth leakage test as per IEC standard?
