Interested to Buy Any Domain ? << Click Here >> for more details...
What is the Difference Between the SCADA & PLC ?
Both it also control and Supervise Then what Special in
Scada & PLC?
- 1 Answers
- 4156 Views
- I also Faced
- E-Mail Answers
Answer Posted / niyaj
PLC is a control device .It Should not monitoring the
process.and SCADA is graphical monitoring device it should
not process any control activities.SCADA interface with PLC
for real time Control & Monitoring purpose.
| Is This Answer Correct ? | 10 Yes | 0 No |
Post New Answer View All Answers
A 7 storey building has a floor area of 35,000sq.ft on each storey. On the ground floor 11KV electrical sub-station is to be erected. A load of 3kw for every 400sq.ft (p.f is 0.8) is proposed for each floor. fire pump 7.5hp, water pump 5hp, lift 2 nos, each 10hp and 20shop load of each shop is 5kw. calculate a. load each floor b. total load of building c. L.T feeders for aech floor and from transformer to main. d. distribution diagram e. capacity of sub-station/capacitor bank f. line diagram
What is electrical cable termination
i have flexible wire. size of conductors is 0.190 mm & no.of conductors are 48. then size of wire comes 1.37 sqmm instead of 1.5 sqmm . the what is tolerance for this size.
what is power factor ? how we can calculate the low power factor and amount of capacitor for improve that low factor ?
If I have Energy Meter Ratio as 100:5 & Also I have CT Ratio as 50:5 then what will be my multiplying Factor(M.F.)
Can any answer me ,What will be the range of C.T coil for L&T energy meter EM301 used for 180 kva DG set
How to confirm the Phase shifting Transformer VECTOR GROUP relation , as below ZNy11.45d10.45-ZNYy0.15d11.15
why does the magnetic balance tests at transformer?
how to calculate the earth mat design in 132 kv substation yard ????
how could we calculate the no of outgoings from a 800 watt distribution board
Which do you think is the most significant cause of energy loss in a factory?
PLEASE INFORM ABOUT THE IDEAL TEST RESULTS OF MAGNETIC BALANCE TEST OF TRANSFORMER 33/11 kv DELTA-STAR T/F
how can i find ct ratio of meter by seeing name plate of meter and how it should be used in MF calculation if it shows only-/1???
What is tranformer differtial?
When a single pase capacitor run motor- run on 230vac and Case(1)run with 8 Mfd 250 vac.capacitor , Case( 2) run with 8 Mfd 400vac capacitor. What is difference between both case regarding power ,efficiency etc?
