Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / amsal
Pressure Transmitter is a device which sense the Pressure (mechanical force) and convert it to electrical signal due to biasing it with 24V dc. And also transmit this signal in Current signals to our contol room.
Only transduction (mechanical to electrical) is not enough to meet a definition of TRANSMITTER.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
Hi, Is there any smart plant instrumentation design training institute in Bangalore?
How to measure the dust in chimney(spm)?
field bus transmitter calibration procedure tell me
model question paper of instrumentation for Jindal GET 2010.plz reply sudhanshukumar08@yahoo.com
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
What is defferent betwen ESP &PCP PUMP .HOW IT IS WORK?
Coal mill Instruments Equipments for cement plant And process diagram ?
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?
What is the purpose of LO Overhead tank in turbines.
what is droop in governer ,type of droop ,how it work
In bently nevada vibration monitoring system,what is the reason to maintain the Resistance of the probe + extension cable equal to 95 ohm? If possible explain the basic principle of measurement with detail electronic circuits.
In apron feeder how TPH is calculated?
how to relay switch sense the fault?
I have 0.75mm sq multicore cable (IS type) , can use instead of same type but 1.5 sq mm cable ? Note : The distance is around about 150 meter.
