Interested to Buy Any Domain ? << Click Here >> for more details...
in our sub station why we step down firstly 33kv\11kv then
11kv to 430v. can we direct step down 33v to 430.v.
- 7 Answers
- 14150 Views
- I also Faced
- E-Mail Answers
Answer Posted / puneet kulshreshtha
IN PAST MANY OF TIMES WE USE 33/.430 KV S/S
BUT IT IS VERY EXPENSIVE SO WE USE 11/.430 S/S FOR EASY
COST AND TRANSPORTATION
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
How you calculate the repturing capacity of a HRC fuse
What the difference between three phase contactor (coil 110vac) & three phase SSR (control voltage 110Vac)? May I use contactor in place of SSR?
explain the functions of main isolation switches
What type of pipe material G.I or M.S is used for sprinkler system?
R=*¶ l/a
Why increase in current leads to increase in conductor temperature?
I NEED RRB SYLABUS FOR JE ELECTRICAL ,PLEASE SEND TO MY E- MAIL ID joo28_eee@yahoo.co.in
why we use sinosidal voltage / current instead of others in system?
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
how to compute kAIC? with formulas...
tell me about eletrical contractor
Define stepper motor. What is the use of stepper motor?
For refrigerators the motor current is raised beyond its rating on both conditions when the voltage of the system is more(say 270v) than the rated voltage(220v) as well as when the voltage of system is less(say 160v) than normal voltageof 220v, why explain?
how the phase convertor changes the no. of phases
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
