Interested to Buy Any Domain ? << Click Here >> for more details...
I know current,volt,powerfactor of an electrical line. In
this line how I will calculate Active power and Reactive power
- 2 Answers
- 4863 Views
- I also Faced
- E-Mail Answers
Answer Posted / v.r. shinde
For active power.
P= V*i*cosQ ( watts) wherw Q is the angle between phase
vol. & phase current.
For Reactive power.
P = V*I. ( VA)
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
Why temperature rise is conducted in bus bars and isolators?
what is difference between 5A and 100A CT constructional wise and operation?
What is the difference between PS & metering CT (5p20,0.5 etc.)? Why in PS class CT only Vk is given ? Is PS class CT is more accurate than metering CT?
How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.
What is effect on in zone and out zone fault if CT chosen for phase side is Vk/2<5mA and Neutral side is Vk/2<15mA on REF protection of Transformer
bus bar design conditions and sizing pls tell me quickly
Why neutral point is consider as zero potential?
What is different between resistance grounding system and resistance earthing system?
What is the test block protection relay if any body know plz explained
What is the rating of circuit breaker needed for 300 KVA load in 33 KV supply line in a transformer of 33 KV / 415 Volt ?
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
How we calculate DC inducation moter Amp? Sir pls give me formula......
What are the advantages of the three-phase motor over single phase motor?
I'm generating a pulse of 3V with frequency 80Hz (12.5ms time period) and pulse duration 0.125ms and feeding it to a transformer since i want the pulse to get amplified around 60V. At the output amplification s happening but the pulse is changed to a spike, can you tell me what could be the reason? (an ordinary transformer 220V-12V stepdown transformer is reverse connected ie. now it is 12V-220V stepup and voltage amplification happens)
hi, could someone help me to find a control design for syncronising panel .
