If we use oil,inner on the column box, it'll make rust on
the column steel?
- 4 Answers
- 5858 Views
- I also Faced
- E-Mail Answers
Answer Posted / abhijit
Oil is applied on the shuttering which is used for columns.
This helps in easy removal of the shuttering.
Steel would not rust because of this oil.
| Is This Answer Correct ? | 12 Yes | 2 No |
Post New Answer View All Answers
cud any one send me tech quest paper(civil engg) at tarizus@yahoo.com
What is Density of cement, sand & aggregate ?
How much wastages taken in 1. cement 2. steel 3. fine aggregate 4. coarse aggregates (10mm, 20 mm)
how many litres of enamel paint required for 5000 sft of site??
How should we design a brick column and footing?(note: no reiforcement to be provided) Can you tell me any reference book where i could possibly find this design? Plz help urgently
how much quantity of cement,sand and water required for 1 sq feet flooring work .
what is idealized curve for concrere and steel
what would be the design load of R.C.C Cooling tower per cell.?
What is the use of water table & Kreb stone for drain
Moisture content calculation for diff mix ratio's ??
manhole height is 1500 mm and width of brickwork is 230 mm dia of manhole covering is 560 mm brick masonry 1:4 horizontal length is 1500 mm and plaster 12 mm thick on both side 1:3. how to estimate the quantity of brickwork with mortar cement and sand for manhole chamber.
what radial pressure, the NP2 class rcc pipe can sustain?
what will happen if one could not properly follow the spacing of slab reinforcement bar?
When column of building is abutting the boundary line,then suitable footing advised is
how do you calaculate the total steel quantity of an rcc building using thumb rule?
