Interested to Buy Any Domain ? << Click Here >> for more details...
hw to calculate flc of motor ? data are:3-phase,50Hz,30kw
- 6 Answers
- 27437 Views
- BRG, Reliance, I also Faced
- E-Mail Answers
Answer Posted / adnan
FLC : Can be Measured By their name Plate
Engr.adnan
| Is This Answer Correct ? | 0 Yes | 13 No |
Post New Answer View All Answers
we have 3.5MVA-11/6KV transformer. how can we calculate earth fault current and NGR calculation?
What is the difference between earthing,ground&nutral?
how to maintain frenquncy with syncronising sub-station for distribution
what is the difference between Central Battery System and UPS in applications and uses? and why UPS suitable for Computers and central battery for emergency lighting?
what is the use of permanent magnet generator in exciter
How can we choose the rating of submersible motors
For refrigerators the motor current is raised beyond its rating on both conditions when the voltage of the system is more(say 270v) than the rated voltage(220v) as well as when the voltage of system is less(say 160v) than normal voltageof 220v, why explain?
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
how can we change the polarity of Alternating current rapidly? how frequency of ac can be controlled and changed easily?
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
A commercial Building is designed with 14th floor levels with indoor substation of three phase transformer with rated capacity of 1000 Kva.The transformer delivered 65% of its rated capacity at 0.67 power factor lagging.Because of low power factor, the power customer was penalized and certain cost was charged accordingly based on every point percentage lower than 85%.This situation may repeatedly happen on the succeding energy bills of power customer.The power customer is desired to improve its historical power factor of 0.67 lagging and no further penalty be impose by the local power company on the next bill. Q: Identify the appropriate solution you want to offer to Client?.Justify SCIENTIFICALLY and MATHEMATICALLY the principles behind the solution.
Is it required to use Automatic transfer Switch in L&T panel board if we use AMF panel with DG set? How the single line diagram will be? Please forward the material to sreenu_207@yahoo.co.in
why the India electrical supply transmission loss is high when compare to us
How to test Alternator stability test for REF relay
