Interested to Buy Any Domain ? << Click Here >> for more details...
what will happen when power factor is leading in
distribution of power?
- 10 Answers
- 23549 Views
- AMET, JTO, Power Grid, I also Faced
- E-Mail Answers
Answer Posted / ankit
i think when the power factor at
distribution side increases, the recieving
voltage increases according to farranti
effect. But at recieving side we dont
require more than rated voltage. It can
damage the equipment by damaging the
insulation, which is not rated for that
much higher voltage....
| Is This Answer Correct ? | 12 Yes | 3 No |
Post New Answer View All Answers
can any one provide me a connection wiring diagram for a DG set control panel along with BOM?
What is the formulae of Megger value for a A.C.Motor
how to measure the transformer resistance values(dyn11)?and howmuch the minimum value?
what is star delta starter? how it works? give its control and power diagram.
what is the function of statics switch in ups and tell me parts
What is the Surge suppresor? Why using in a UDB's and How it works?
how can you calculate fault level ?
If anyone would like to know or practice for FEWA papers contact me on mohamedrashad2@hotmail.com Just completed the supervisor exam in April 2021
What happens to voltage when current through the inductor is constant?
when ac current flows thru d coil of a contactr,it energizes,magnetic field attracts d contact of the coil...nw wont dt ac current in d contct induce current back on to d coil thru mutual inductance leading to high currnt in d coil
Don't you have similar question banks related to Oral Certification Examination conducted by Mercantile Marine Departments / Directorate of Shipping, Ministry of Shipping for Electro Technical Officer?
Why temperature rise is conducted in bus bars and isolators?
What will happened if the neutral of secondary of Xformer ( Star point) Note it's above KVA rated Xformer
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
What is the maximum and minimum rating of UPS?
