IF avr is voltage regulator of genset means why we are
giving genset CT sense to AVR ?
- 3 Answers
- 5431 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / gunasekaran
avr are 2 type one is voltage detection another one is load
compensation for voltage detection inout is voltage for
load compensation we have to give both voltage and current
so we r using gen avr are loadcompensation type
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
what is ratio of copper wire size and current ?
what is the advantages og idmt relay over magnetic relay??
please send 5yearje solved papers on my email himmatsinghnathawat@gmail.com
How to check the LM324 Ic
WHat is the general checks required for Dry type transformers
What will happen if we on 200kvr capacitor bank(11kv in bus)If there is low load on transformer (1.5 mva 33/11 kv)
Please help me regarding my one concern. - During earth pit testing we noticed that the Clean earth pit and dirty earth pit showing continuity (Resistance value - 5ohm) . I want to know that if both earth pit have separate location and there is not internal looping between PIT then why such continuity is showing on it . Because of this issue the field side all earthing point showing short. In PLC panel we are providing two types of earthing cable which is coming from separate earth pit (Clean and Dirty earth pit) because of earth PIT showing short our PLC is not complying spec . please help regarding this issues.
lorteny method
I am designing new project sub station with 220 kV / 11 kV, 40 MVA capacity. This project have many recifier sets, which can generate 3rd harmonics. Now I have to select vector group of This transformer. To minimise 3rd harmonics, what care should I take in selection of Transformer Vecrtor group? If it is Y-Y with open Delta tertiary then what should be the rating & voltage of Tertiary Winding?
On what principle electric motor works?
What willbe change in programming when we use 5/3 solenoid inplace of 5/2 in operating of a cylinder?
The efficiency of a 100kva transformer is 0.98 at full load as well as half load , for this transformer what is the Copper loss at full load ?
How to select transmission line type (i.e. 11kv or 33kv) for new established industries
why use phase displacement in transformer.and effect of phase displacement on transformer
two phases with neutral supply can be taken in 3C X 10 sq.mm cable .
