Interested to Buy Any Domain ? << Click Here >> for more details...
which trsanmission is easy and cost effective AC or DC.
- 19 Answers
- 20345 Views
- I also Faced
- E-Mail Answers
Answer Posted / saurabh kumar
according to my knowledge up to the 600km transmission
ac is economical but after 600km dc is much more
economical.this thing can be analise from a graph.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
HOW TO CALCULATE EARTHING SIZING?
Pls tell me whether we can use EN3A material for shafts of Permanent magnet alternator.What will be the effect of magnetic and nonmagnetic material for shafts on magnetic properties of PM rotor .
Is it possible to connect a safety device in to parallel?
What type of pipe material G.I or M.S is used for sprinkler system?
when we gave dc supply to 220v dc motor its rpm is 1200. then we gave 180v. how many rpm of its motor. gave answer with calculation at my ID.... ravizak@ymail.com
why is control bus bi-directional?
What is non-minimum phase transfer function?
1. How many types of mangers? 2.How many types of capacitors? 3.pls tell me normally types alternator problems?
where is the need for short circuit test for 3 see is required and why? can you explain in brief with application
how to find out cable size if load is 2800 watts, 230 volts AC supply and load distance is 1800 meters
What is Antipumping Function & If we have C.T how we find the Ratio ?
Haw to check conductivity of budbar
Safety of dry type transformer
what is the physical connection of a analog i/p to a analog i/p module (ab plc)and through a analog o/p module(ab plc) to a analog o/p . and how all the process control by scada
What is the requirement of grounding the neutral of single phase generators on load? If the neutral is not grounded, what will be the effect?
