Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ramanjaneyulu
IT IS A MACHINE WHICH CONVERTS MECHANICAL ENERGY IN TO
ELECTRICAL ENERGY IT WORKS ON THE PRINCIPLE OF FARADAYS
LAWS OF ELECTROMAGNETIC INDUCTION
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what questions will be asked for 11/33KV licence interview APSEB hyderabad. Can any one share question and answers.
at what rate the micro controller increment its timer....is it 1micro seconds or 1/(12*10^6) seconds
Determine a suitable number of slors and conductors per slot for the starter 1 winding of a 3 phase, 3300 V. SO Hz 300 rpm alternator. The diameter is 2.3 m
how to interlock 3 nos MCCBs using under voltage coil. please provide me circuit diagram?
# 4 hi friends i m from electrical branch and seeking for tech. + apti. both papers of hpcl plz get it available as soon as possible my email id is sumit_lig189@yahoo.co.in
what is meant by loss of field in a DC motor? how a universal motor works?
why burdens of VTs is more than CTs?
Hoe do calculate the Cable size for Amps rating ?
what is the difference between b c d curves on mcb
What is VSCF windelectrical system?
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
If we need 4c× 50mm sq cable but it's not available so we can pull 4c×25mm sq two cables?
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
In what cases (circumstances)we should apply P controller, PD controller, PI controller & PID controller ?
why we are using Load factor?
