Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / kumar
A cascade control system is a multiple-loop system where the primary variable is controlled by adjusting the setpoint of a related secondary variable controller. The secondary variable then affects the primary variable through the process.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
what is performance test.need defination
the 3 most common transmitter protocol being in refinery or qatar gas and aramco.
I have 0.75mm sq multicore cable (IS type) , can use instead of same type but 1.5 sq mm cable ? Note : The distance is around about 150 meter.
Derive capacitance to 4-20ma conversion formula / relation in capacitance type pressure sensor?
What is the use of control cable?
Can any one tell me what type of question asked for instrumentation and control interview panel??? pls mail ramashankar.goel@gmail.com
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
Type of level transmitter commnly used in Procees area are the following. a.________________This type of level transmitter works as follows
I WANT SECURITY PAPER MILL, HOSHANGABAD TEST PAPER.KINDLY SEND TO MY MAIL ID
Drum level tx with GP4 with zero elevation:7300mmh20 on HP and 8050mmh2o on LP as range but on commissioning the tx readiing is max,Why this reading?
How will you test a transistor with a multimeter?
How the warning lamp of a charging-system is activated ?
How many ohms are required for proper earthing?
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
why we are using digital signals for I/O & how to measure this signals is getting or not ?
