what is the disadvantage of leading power factor...why can't
we use it (pf=0) for a long period of time?
- 10 Answers
- 33141 Views
- Appco, snsce, I also Faced
- E-Mail Answers
Answer Posted / m.s.kailash
In practically it is not possible(i.e.power factor=0).If
Theoretically power Factor=0,means there is no actual
power(true power).(i.e.only wastage of power).
i think your i question is wrong pf=0 means lagging power
factor.
there is no disadvantage of leading power factor.
if lagging power factor means more wastage of power
| Is This Answer Correct ? | 6 Yes | 13 No |
Post New Answer View All Answers
we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan
what is effect of leading power facter on the system and billing
hi can any body send me syllabus of rrb electrical section engg... and past pepar also of any board...
What does the a,b,c of 95a,95b,95c relays denotes?
How you will determine the volume of oil in a particular Distribution transformer.
what can be the causes of capacitor start motor having a higher current that its actual
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
What is the basic of DTH.
How will be the single line diagram of series trip HT breaker? how it works?
EXPLAIN WHY THE SURGE CURRENT RATING OF AN MCCB OR CIRCUIT BREAKER DECREASES WITH INCREASE IN THE RATING OF MCCB OR CIRCUIT BREAKER.
TRANSFORMERS WITH DC SUPPLY
i want wipro vlsi placement pattern please send me
how to design the heater in temperature control unit to heat 50KL of water?
Define pole pitch?
what is plunger and what's the use of it in motor alignment?
