Interested to Buy Any Domain ? << Click Here >> for more details...
what is the need of representing AC power in sinusoidal
waveform? why not in square or rectangular etc...
- 8 Answers
- 11241 Views
- Lanco, I also Faced
- E-Mail Answers
Answer Posted / pandu
sinusoidal gives accurate time period
| Is This Answer Correct ? | 1 Yes | 5 No |
Post New Answer View All Answers
what is fault level of power system ?
In the ACB breaker capacity is 2000Amp but this each phase taken 1250 But total beldibg load is 600amp or 700amp watt is the problem
advantage of motor design on higher power factor . normally motors are designed for .8 power factor. what is advantage of designing at .88 power factor
Two liquids hot and cold in two vessels are there and an metal bar acts as a conductor of heat between the two vessels. what happens then. what happens after 24 hrs?
how to calculate maximum current
What is the need of generator relay panel
why magnetising curve not start with zero voltage?
what is ps impedance test
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
What is corkscrew rule?
How to check the thermocouple is correctly connected to cable for K type? (i,e positive pole is connected to non magnetic conductor and negative pole is connected to magnetic conductor)
hi this is hema can anyone mail me previous years questions for the APPSC-A.E.E (in electrical stream.) ......thank u.
Good morning: I'm looking for some informations about the OLTC or the LTC: I wont to know what the function of the tie-resistor in during the operation of reversing/coarse operation Cordially
What is the purpose of stand by earth fault protection for transformer ?
when we have to use UPF wattmeter and LPF wattmeter? what is the difference between UPF and LPF wattmeter in terms of construction?
