What will be the total current for 300kva UPS if it runs on
40 to 45 percent load. Is there any formula for to
calculate the exact load.
- 4 Answers
- 17561 Views
- Sodexo, I also Faced
- E-Mail Answers
Answer Posted / sathishbabu t
same 40 to 45 % of full load current
| Is This Answer Correct ? | 0 Yes | 4 No |
Post New Answer View All Answers
what are the condition that makes hooter blow?
Does all the output contacts (N/O as well as N/C) of a Numerical relay operate when relay receives a binary input/inputs or contacts are designated to specific logic input/inputs and only these contacts operate?
how to meas-our losses for L.T & H.T
in a solar power plant,we are going to step up the voltage 350V to 33kv, and to 132kv GSS. i want to ask that if it is possible that 315v/33kv is not possible because we also use 315v/11kv. or it should be 415v/33kv? is it effects generation or losses? the second question is-generation is depends on LV winding? or LV winding design for generation voltage?
Draw the circuit of clapp oscillator?
How is the resonant peak, resonant frequency, and bandwidth determined from nichols chart?
How can we calculate strength of copper hich is supplying electric power to heater and in it hold the heater also and what r all types of forces which is acting on it...
how to determine the inrush current of a transformer
How to dimensioning SDCCH, LAPD and CS7 signaling on GSM?
How much depth n width required for laying of 1X70 Sqmm Cable in Desert???
what is the role of transistor in Circuit?
What is bridge rectifier and explain with details
what are the basic insulation levels & what its Unit
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
which phase is preferred for connecting 1 phase vt used for synchronizing OHL? WHY?
