Interested to Buy Any Domain ? << Click Here >> for more details...
why loss of strength in concrete in 7 days cube test i am
not geting mim 7 days strength that is 67 percent for M-35
and my mix design is perfect there is no doughty,and my
results are near to 7days percentage but not 67 percent.
- 4 Answers
- 10923 Views
- UPPSC Uttar Pradesh Public Service Commission, I also Faced
- E-Mail Answers
Answer Posted / sjtbehera
what you sure about your mixing. you check slump test, you
check bulkage of sand, you check waste of cement while
mixing, you check compaction factor, if this is right then
result is not obtained please contact Indian standard Buero.
| Is This Answer Correct ? | 12 Yes | 1 No |
Post New Answer View All Answers
What should be the maximum allowable time for placing ready mix concrete? The specification requires concrete placement within 90 minutes of batching at the plant. What is the significance of this 90 minutes & should this be used as a rejection criterion? What effects does the concrete has after that time period?
How long does it take concrete to harden?
Explain the mechanism of cavitations in pipes and drains?
What is demising walls?
how to find ssm in foundation?
What is pre-stressed concrete?
how much to get of BRC lapping in full yield and half yield ?
How much sand and cement requirement for 1 SQM 125mm thickness Brickwork
natucher of concrete &type of concrete?
i have boiler of 35 tone and wanted dig out foundation is there any body to help me to carry out calculation for the foundation like
who to find building iron rod strenth
A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.
I want to know how much the lapping length for the pilecap reinforcement.. we r using single pile cap which is 24mby54m and 2.5m depth.. total 91piles are supporting the pile cap.. how to do a steel reinforcement??
Material calculation of cm 1:6 for 1sqm
what is the tensile strength of 10swg and 8swg gabion wire?
