Interested to Buy Any Domain ? << Click Here >> for more details...
What happens to an electric motor if it has poor or no
ventilation. Will it burn out? If it will, how long it
will run before it burn out?
- 5 Answers
- 7868 Views
- GMC, I also Faced
- E-Mail Answers
Answer Posted / mrt
for running motor cooling air fan at non drive end side is
important because the motor winding temperature is
increases. if cooling fails the motor temperature increses
and sometime depends on the load the motor will burnt out.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
What is the temperature PROFILE OF A FLUID W. R. T. Distance from a sphere to which it is IN CONTACT which is at constant temp.?
which phase is preferred for connecting 1 phase vt used for synchronizing OHL? WHY?
What is the different types of cable & current capacity of cable
A 3-phase IM is supplied from 50 Hz system. It runs at speed of 1440 rpm and slip equal to 4 %. Calculate number of pole pairs. A 1 B 6 C 2 D 3
How to measure the Harmonic Distortion of UPS ie THD?
I have doubt that the supply HZ (very low or high than rated ) may affect the power factor. is it true. ?
Explain few advantages of electric traction system?
State ohm’s law?
Dear all, I'm manikandan I have done by DIPLOMA EEE from 2011 , I have 5 years of experience from Power plant instrumentation field , which one field is give long life & which one field is best ,I confused a lot and also I'm studying AMIE, can I choose which department from Section B examination? pls tell me
Why is the air gap between the pole pieces and the armature kept very small?
If 24 KVA AVR having Input voltage 200-400v, Output voltage 415+-1%, what will be the voltage if Load is 13A.
in non technical way how can u define POWER FACTOR??
Dear sirs, pls check this 4-20ma to RS485 module datasheet,pls guve me some suggestions. http://www.szsunyuan.com/sy/pro_more.asp?Productid=539 Thanks. E-mail:yunianjiang99@gmail.com
In HVDC LINE RECTIFIER CONTROL ON CONSTANT CURRENT AND INVERTER CONTROL CONSTANT EXITATION ANGLE CONTROL BUT HOW INVERTER CONTROL CONSTANT CURRENT?
how can we calculate the ampacity of the electrical wire/cable. and what are the factors must be considered. pls. elaborate.
