Interested to Buy Any Domain ? << Click Here >> for more details...
What will happen if the oil level in the buchholz realy of
a transformer gets down?
- 3 Answers
- 6952 Views
- I also Faced
- E-Mail Answers
Answer Posted / ashoke
The buchholz relay will operate in high fault condition only
and there will be no primary alarm due to low oil lebel in
the primary stage of the fault and the X-mer in high risk
because the secondary switching will be depend upon the
quantity of gas formation .
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
what is the use of Auto re-closer?
what is the difference between pvc & fiber glass cables
What is the difference between Droop vs Isoch Control?
Why we use Electrical energy rather than any other type of energy, mostly? Explain behavior of open secondary CT and short circuited secondary PT in energized condition?
How can we calculate the motor frame sizes?
why the colour of insultor stack , petticoat is brown. Is it has some technical reason.
WHAT IS THE CURRENT CARRYING CAPACITY OF 2.5/3 CORE HI TUFF CABLE,WILL IT SAFLEY CARRY 8.6 AMPS OVER 120 METRES,CAN YOU ALSO ANSWER WITH FORMULA FOR WORKINGS OUT ,THANK YOU 3RDYR APPRENTICE.
how much LT load can bear by the 100 KW HT connection.
sourse is 66 KV / 350 MVA, transfarmer is 1000 KVA 6.6 / 0.415 kv, iF fault is 28.75 MVA on 0.415 KV Bus then calculat the Transfarmer Impidance
I have 440v power coming to facility,( not being used ) can I buy large generator, (gas) to sell power back to electrical co.
How to calculate phase to phase difference ?
what curve and rateing would you use for a three phase 0.75kw motor?
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
Why does the speed regulating system adopting I controller have no steady-state error? In this single closed-loop speed regulating system, when the input of the I controller Un=0, what is the output voltage of the regulator? What factors do the output voltage depend on?
