Interested to Buy Any Domain ? << Click Here >> for more details...
Is a DC Transformer Possible? if Yes, Then Why, if not Then Why?
- 9 Answers
- 18963 Views
- I also Faced
- E-Mail Answers
Answer Posted / naresh
it is possible for small applications.the ransformer will
work for small period of time for given DC input as it will
produce little amount of flux for some time, but not
constant.as the flux is not constant, we prefer AC
transformer.
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
A 7 storey building has a floor area of 35,000sq.ft on each storey. On the ground floor 11KV electrical sub-station is to be erected. A load of 3kw for every 400sq.ft (p.f is 0.8) is proposed for each floor. fire pump 7.5hp, water pump 5hp, lift 2 nos, each 10hp and 20shop load of each shop is 5kw. calculate a. load each floor b. total load of building c. L.T feeders for aech floor and from transformer to main. d. distribution diagram e. capacity of sub-station/capacitor bank f. line diagram
can any one know is sbi interview based on merit or based on roll number
What is a fuse? How does it work? What are materials used?
Single line diagram for dbb (double bus bar)system.
when elecromagnatic waves are propogated in a wave guide?
Please brief working principle & construction of permanent magnet AC Servo motor
how does grading rings & spacers in transmission line works? Working Principle?
Can we convert off line transformer to on line transformer
What is an 86-P or an 86-A trip
How many points does a Circuit can have?
how to test YNyn0 vector group in transformer?
Why a tesa lamp is glow between two phase?
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
Hi everyone, I'm Lachuu, recently joined automation company as PLC Engineer. I have certain basic question, I request all big gurus and seniors to answer these question. Because this will be very helpful to me as well starters like me. How to design a control circuit (ex: pick & place - my current project) Yamaha robot PxYx series controller RCX222, using 6 cylinder double acting, plc keyence kv p16r 2 expansion unit for input and output each. How to select panel terminal mcb elcb powersupply. My main concern in some projects how to select dc power supply, mcb rcb(I came across dif bt b c d curves, but stil confusing, pls help me :-(. I would really appreciate all who are going respond to this question.
What is CCM in Electrical ? where can we use this material?
