Interested to Buy Any Domain ? << Click Here >> for more details...
can any one pl explain me in brief that how we select the
leakage classification in valve,means for liquid or gas
there is any standard for selecting leakage classification
or its depend upon valve size or any any other parameter.
- 3 Answers
- 5866 Views
- I also Faced
- E-Mail Answers
Answer Posted / sam
I cannot remember to much about this but I remember that the
leakage rate is dependent on the valve classification. a
Class 6 valve is a tight shutoff valve with not leakage
tolerance at all. a Class 5 is classified as a modulating
valve and have a tolerances of a small amount of droplets
per minute and so on. The lower the class valve the higher
the acceptable leakage rate. This leakage rate is tested in
a valve shop either by the manufacturer or on your own site
if you have the right equipment to do it with.
We normally had it done by our valve shop after we send a
valve to them for a complete overhaul. Once the control
valve have repaired and overhauled the valve, we had to do
the final testing and acceptance with them. They would
supply us with the specs on the valve so that we can see
what class valve it was and what the acceptable leakage
tolerance was. After this we would witness the testing of
the valve and sign a acceptance certificate.
I suggest you get hold of your valve shop or the original
manufacturer to supply you with a list of the
classifications of the valves you are currently using or
want to use as well as the various acceptable leakage rate
for each class.
Good luck
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
Draw block digram for well head from well to shipping pump?
Im having problems with interfase betwen SPI v7.0 and SPPID v5.05. Previous versions of Intools shoul be fixed with SPPIDproj.ocx file. It was necessary to replace this file with one that allows the connection between different versions of SPPID. It is necessary in the current version to do the same?Thanks
What is zero elevation and zero suppression?
what are the diff. in servo and regulatory control?
while i check zero check for dp flow transmitter some fluctuating came (0 to 458 kg/h) what is the reason?
Why humidity limit is 30 to 55 % for raw material storage?
hello friends, can you please send me the model paper or question paper to be prepared for hpcl examinations????????? You can mail me at rahim_here@yahoo.com waiting for your reply........... help me .. plz.....
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
we want to control pump in let pressure and tank (for exp) our inlet line if water cam and pump will on and when our tank will full pump will off also if our inlet pressure low pump will off even tank not full.this pump i want to uses on our water supply line.
where proximity sensor installed on tank in loading arm application
selection criteria of control valve? and selection criteria of actuator explain in brief?
Why ac supply load cell is used? Can we use the dc supply load cell?
detail of mass flow meter pricipal
basic connection and principle of axial shift sensor n differential sensors in tubine describes n draw......
To become an Instrument DESIGN engineer, is there any softwares or training to become Instrument Design engineer, plz suggest me, Iam very much interested in designing.
