why capacitor bank always connected in delta,why not in
star to a system?
Answer Posted / debasish
Capacitor is used to balance the line inductance and hence
to increase the power factor. The effective capacitive
reactance is 3 times more when connected in parallel than in
series. So, to improve the p.f. by a fixed amount, the
capacitance required in parallel is 1/3 of capacitance
required in series. So, the cost is less for parallel
connection.
Is This Answer Correct ? | 82 Yes | 9 No |
Post New Answer View All Answers
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
How equivalent impedance is calculated in thevenin theorem?
some basic standard questions on transformer.
concept of busbar and load dispatching..?
if the number of poles generated in stator and rotor side of an induction motor are different then what will happen and why?
what is the need to express current and voltage in rms value? rms value is also called as effective value,what is effective value?
why 15 kw motor winding resistance is low then 5 kw motor winding resistance?
What is the necessary and sufficient condition for stability.
Please define ohm’s law for a.c (alternating current)?
what is the requirement regarding earthing of Single conductor with AWA
what is the vvvf in the dumbwaiter?? or lift. what is the actual process?/
hi if anybody got model questions for cpcl Grade'A' electrical engineer position.send it to my mail please krishkumar22@gmail.com
What is voltage ratio of a transformer?
what is the standard values(Megger test) of resistances between L&N,L&E and N&E for a system on IEE regulations?
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.