Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / kumarsekar
it is switch when current and voltage increased in that specification
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
what is buffer resistance starter.?.What is the working principle and where it is used..?
HOW TO CALCULATE AMPs OF CURRENT TRANSFORMER IN HT Panel
can i able to get bhel previous exam question paper?
how do you choose the cable size as per amps rating & the voltage drop for the same.
Why we are using only Dyn11 tranformer in distribution system but not using a Dyn1 in distributing system?why not and advantage and disadvantage in both
How to calculate fault level of 11 KV system
- two pumps must work with them at the same time but if the first pump start the second pump must delayed for some time to start also , with motor rated power = 90 KW and rated voltage = 380 V and rated power factor = 0.85 lag please draw the power and control circuit for it and determine all circuit components parameters that you use it
Any one can explaination about calibration with rotating sub standards?
what is the concept of directional power?
On what basis do you decide the ONAN (Oil Natural air natural) or Dry type transformer for a project?
why did youi choose this career?
What are the uses of stepper motor?
How is the gain affected by the introduction of feedback in a control system.
Why PS class CT is always preferred for Differential protection?
How will be the single line diagram of series trip HT breaker? how it works?
