Interested to Buy Any Domain ? << Click Here >> for more details...
1. alternator has full load regulation of 4% when pf of the
load is 0.8 lag, 1500 rpm. full load regulation of 1400 rpm
for 0.8lag will be ________ ??
2. torque angle of a sync m/c operating from a constt
voltage bus is usually defined as space angle between _______ .
3. method most effective in finding out no load losses in
large DC shunt motoris ______ .
4. current carrying capacity of fuse material depends on
______ .
5. coil has res. 10 ohm, inductance 1H. what wil be current
after 0.1sec after switching on to a 500V DC SUPPL ? ?
6. effect of phase lag compensation on servo systems
___________ .
7. rotor of a dc machine is usually supported upon ______ .
8. DC motor is preferred to AC motor in which application ??
9. 3 nos of 10:1 Xmer are connected in Star-Delta to supply
a load at 230V.the supply voltage must be ______ .
10. voltage source produces max current in which circuit.
11. cal. power, if current and voltage are out of phase by
90 degree.
12. suitable length of Xmission line of power at 66 KV.
13. Which of the theorm helps in simple computation when the
load across a ckt is varying ??
14. what is the adopted line length for power Xmission of
power by cables ??
- 5 Answers
- 8741 Views
- TATA, I also Faced
- E-Mail Answers
Answer Posted / rajnikanth
for the nineth question the answer is 2300*3^1/2
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
why capacitance effect is predominant in underground cable transmission and inductance effect is predominant in over head line transmission?
If SFU is Switch Fuse Unit, What is the expansion for FSHF in Electrical Engineering?
1))why we run three phase or three different circuit from a single conduit 2)) why not two circuit of different phase run in same conduit?? and why we run same three cicuit of same phae run in single conduit??
What are safety device in vcb and acb?
Why do we perform an open-circuit test and short-circuit test on the transformer?
Pl.brief me any electrical major fault you have rectified.
Inverter. converter. Ups.MCB.solar.alternators. motors.
Explain about retrofitting of machine tool.
Why we make earth connection with Transformer Body and What will be the minimum size of copper wire as per code with respect to KVA rating of Transformer?
how to ctrl motor by use of ac or dc drive.plz explain evdintly
WHERE CAN I GET THE PREVIOUS QUESTION PAPERS OF Govt Polytechnic in deee 2nd year papers
Match the following a)(X'+Y') b)X'Y' C)XY 1)NAND 2)NOR 3)Carry
I AM A ELECTRICAL PANEL BOARD DESIGN ENGINEER.IF I GO ANY INTERVIEW ,TECHNICALLY WHAT ARE QUESTIONS I WILL FACE FROM INTERVIEWER?
Difference between low impedance and high impedance Restricted Earth Fault
how to produsing geretor power
