Interested to Buy Any Domain ? << Click Here >> for more details...
what is full form of SMART
- 46 Answers
- 90991 Views
- Infosys, ITC Infotech, Lanco, Rosemount, Solvay, I also Faced
- E-Mail Answers
Answer Posted / irfan khan
Specific Measurable Achievable Realistic Time-bound
| Is This Answer Correct ? | 18 Yes | 8 No |
Post New Answer View All Answers
what is the imbustion control loop
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
what is maxdna ?. explain about the software details.
How process line mpm calculation is done?
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?
How RAL(Rotary air lock)works in cement industry?
Why upper weighing limit of electronics balance is 90% of the total weighing capacity?
protection relay watchdog contact operation?
how to work MIL contol valve posistioner ?
few questions on RS 232,1 question on relationship of impedance and turns ratio, many questions on flowmeters
Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
Why trim span ? How?
What is Cavitation in a control valve?
