for a 11kv transmission line what capacity of CTs & PTs are
required?
Answer Posted / khalid k usafzai
for installing cts and pts on 11 kv line first of all the load to be connected is required.then we will proceed.bye
Is This Answer Correct ? | 5 Yes | 3 No |
Post New Answer View All Answers
what is ps impedance test
Q.1:What protection will be used on HT and LT side of 33/0.4 KV, MVA transformer. Indicate capacities of protective device to be used. Q.2:Which types of back-up protections are used in the power transformers? What do you understand by the term over travel in the relay? Q.3:How star and delta connected winding transformer are provided from earth fault
1. What is maximum permissible distance between smoke detectors ? 2. How do we decide number of smoke detectors required in a large office, warehouse, hall etc ? 3. What should be maximum height of smoke detectors ? 4. Where do we use heat detector, optical smoke detector, temperature sensitive detector ?
Can u explain : what is supply for train (whether a,c or d.c ).I know that supply is 25000v a.c .But there is rumour that supply is D.C. And also explain how lights and fans inside the trains are working ,and what type of motors are used in trains whether D.C motors or induction motors .If d.c motor, how it gets supply.If traction motors are used then what are traction motors and its functions and how it differs from other motors and also explain about locomotive . y d.c series motor in train.train wheels r driven by D.C shunt motor ,at what voltage,and at what speed. please reply..............
I want formula to calculate cable size as per load given in length & amp. I searched many sites but didn't right answer. Please reply me asap.
What happens if we connect a single phase energy meter in reverse polarity.
What is difference between YNyn0 and YNyn ??
Is it possible to implement Restricted Earth Fault protection for a transformer without neutral CT?
what is frequency response?
what is kvarh? Please define it With calculation General motors ?
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
What will happen if the armature resistance is in minimum position and the field resistance is in maximum position while starting the motor
Determine the BTU size of an aircon for 20 sq metre room
I want to know Electrical Circuit?
Mention what are the types of semi-conductors?