Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sanaullah
1 hp motor will be fed by single phase supply... three
phase supply is not reqd ...as the rating of the motor is
low
| Is This Answer Correct ? | 7 Yes | 9 No |
Post New Answer View All Answers
What are the advantages and disadvantages of short-pitched winding?
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?
While testing a ZCT what parameters have to check or measure?
Differenciate between circuit wiring and sub main wiring with illustrations
sir i had plane to do some project with the base of hopkinson test in AC supply its possible
A cable with concentric PE conductor must be used with frequency converter circuits what does its means.?
For a 6.6kV Motor it is recommended to do megger test with 500 V d.c and not more than 5kV d.c but the Hi voltage withstand test should be performed by 12kV AC. Why the dc voltage test should be limited but AC voltage withstand test could be with such a high voltage?
Terminal blocks is used for segregate the connections... There is any principle for terminal block..?
How will be the single line diagram of series trip HT breaker? how it works?
what is sevice settings for mccb?How can be it setted?
Why a tesa lamp is glow between two phase?
in ring main system we use the isolater b/w transfer bus and main bus if we r not use isolatar than wat will be the effect in our sys.
what is meant by twilight switches 7 where its applicable ?
why ht cable end termination don't have a gland?
Can anyone explain me about the RLC based Impulse high voltage generator and how to and operation of Series resonant High voltage reactor...?
