Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / aju m paulose
0.1, 0.2, 0.5, 1, 3 are Accuracy class
They are used for metering purposes
5P10, 5P15, 5P20 are used for metering and protection purposes
5 indicates Composite error in % and 'P' for protection and 10 means accuracy limit factor...
i.e the CT will have 5% error if the current under measurement is 10 times the normal value
| Is This Answer Correct ? | 19 Yes | 2 No |
Post New Answer View All Answers
Why L.T.Cable voltage rating is 1.1kV,where as system voltage is 0.415kV?
How to confirm the Phase shifting Transformer VECTOR GROUP relation , as below ZNy11.45d10.45-ZNYy0.15d11.15
In a synchronous motor. if start is running at high speed. What will be the starting torque : Higher Lower Zero
what will happen if earth of 33 kv cable (earthed system) is not connected to earthing pit?
We have given to 3phase supply to ups system & how can coming netural
in battery charging room we find two fuses (one in positive other in negative cables ).why it is so?one fuse is ore than sufficient?
What it the purpose of parallel phasing transfomers??
in 6.6 kv vaccum circuit breaker vaccum bottole vaccum capacity ????
LT cable fault chaecking equipment and to find out the distance at what distence it failure . Name and where it is available?
UG cable sizes were specified in sqmm. But practically its not coming to mesure. What's the reason for that? And how they specify the size of the cable?
What is transmittance?
explain supply side and demand side energy management with advantages & disadvantages
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
1) why a dg set shows variation of power factor and load when synchronised with other dgs? 2)Why the load sharing is not become equal in all dgs?. 3)When a dg set will not run on auto start?
If we are given a 10 amp cable type and asked to calculate the number of cores used and the thickness of the cable, how do we do it?? please help...urgent!! i hope the question is clear enough!!
