Interested to Buy Any Domain ? << Click Here >> for more details...
a motor's measured current is 45amp,whereas the rated
current is 38 amps but still it is running ,how?
- 5 Answers
- 7724 Views
- I also Faced
- E-Mail Answers
Answer Posted / sam
ya after the winding overheats it will damage the motor,
the check O/L relay setting and its functioning we had the
same problem.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
please give some hindalco placement papers for written exam
what is the difference between single ratio, multiple core and multiple ratio, multiple core ? please explain.
how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
What is precision of a measurement?
Define de-sensitivity?
What are the symptoms of a bad PG card of a drive (inverter) esp. of Yaskawa Ac Drives (inverters) G7 ?
Why the unit sizes of hydro generating machines are not standardized as in case of thermal powerplants?
WHAT R THE SAFETIES IN A HIGH TENSION PANEL N LOW TENSION PANEL. ALSO WAT SAFETIES R THERE IN A 200 KVA TRANSFORMER?
how to determine motor size for a fan application?
why are distributed windings generally used in alternators?
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
Can anyone tell me some hints about what type of questions are asked by the interviewer by an Electronics engineer when company is installing an IPP and wants a team of engineers?
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
Vibromotor 252MV 1/4HP2P..what is mean by 252MV?
