Distribution Transformer are connected in configuration?
a. Star/delta b. delta/star
c. star/star d. delta/delta
- 7 Answers
- 12236 Views
- IPR, Maruti Suzuki, I also Faced
- E-Mail Answers
Answer Posted / subash nishad
in distribution transformer we are using delta/star
configuration because many consumers having single phase
load .for this one phase and neutral is nessesary. from
delta / star configuration we can get neutral.
delta/ star is correct.
| Is This Answer Correct ? | 16 Yes | 0 No |
Post New Answer View All Answers
what is the use of sdf?
What is the effect on in Zone and out zone fault if Phase side CT is Vk/2<30 mA and Neutral side is CT is Vk/4<30 mA for Transformer REF protection
How can we calculate cable size in Low voltage & high voltage
how much flux density of CRNO core
whati s the sludge current in ups
What is Servo Ventilated Motor?
how to calculate short circuit current for the busbar
Is there any specialised book to refer about fault level calculation both in MV and LV side??
On 400 amp factory load how kvarh capacitors provide
why we use single core 630mm2 cable for transformer secondary side
What will happened if the neutral of secondary of Xformer ( Star point) Note it's above KVA rated Xformer
what is size of 3phase 4wire cable to be used for 11 ton ductable A.C and how to calculate cable size for different load
What are the conditions for sustained oscillator or what is backhouse criterion?
Q: How to calculate Transformer losses , tell us by Formula.
What is limitedly stable system?
