Interested to Buy Any Domain ? << Click Here >> for more details...
How to ensure vibration sensor functioning accordingly.With
out using an other sensor.
- 3 Answers
- 8273 Views
- ACC, Oil India, I also Faced
- E-Mail Answers
Answer Posted / guest
sensor use in prevented functiion. sensor use in fire syes
team
| Is This Answer Correct ? | 0 Yes | 4 No |
Post New Answer View All Answers
What are the different types of thermistors used in industries? How to the operation of typical thermistor?
what different types of problems do occur while doing instrumentation commisioning and how to solve them? please explain in detail
What is the right procedure for adjusting the gap voltage of bently nevada vibration sensor?
Whatis the reset ofset and control system in instrumentation
what is the difference between scaler and vector drive
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Describe the function of Accumulator into the Pump
How to check vortex flow meter is in good condition while we do not having calibration setup?
typical loop drawing of a simple feedback control comprising of one transmitter and one control
A length of steel pipe is used to carry sea water to a desalination plant. An adequate corrosion allowance must be specified and indicated in the piping specification, which affects the _________________________ of the pipe
Why do you want to work here
what is the process to make control schematic ?
how u calibrate pneumatic n motorized c/v?
What is the calibration procedure of Drum level transmitter if range is 0 to -400 mmh2o in lab?
Explain operation of Haskel pump.
