Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between electrical & electronics
- 245 Answers
- 364136 Views
- Axon Constructions, Banking, GDA Technologies, Infosys, MBA, Satyam, Satyam Tech, Snow White, TCS, I also Faced
- E-Mail Answers
Answer Posted / umesh kumar
electrical is a branch of engineering in which we read about generation,transmission and distribution of electrical energy.and elctronics is a branch of engineering in which we read about the status of electron when these electrons passing through a vacume tubes,gases and semiconductors devices.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what are the installation procedure of high voltage power transformer,CT,CB&PT?
how to calculate the capacitor to maintain power factor?
A 500 V shunt motor runs at its normal speed of 250rpm when the armature current is 200A. The resistance of the armature is 0.12 Ω. Calculate the speed when a resistance is inserted in the field reducing the shunt field to 80% of normal value and the armature current is 100A.
1)How much current can a 3-1/2 core 100 mm wire carry? 2)What are the special cables required for explosion proof wiring? 3)In case you do not have coal and salt for earthing, how can you achieve good temporary earthing? 4)One horse power single phase motor is more likely to get hot than a one horse power 3 phase motor. Is it true or false, if true why? 5)What are the different types of soft starters for large motors?please explain?
I had applied for JE in PSEB, Can you pls send me the Question bank for related to my field
plz send me HPCL apptitude paper.. maulik_elect@yahoo.co.in
why we use two slope(differential & restraining) in differential relay.but in busbar protection differential we are using only one slope?please explain
What is force on parallel conductors ?
why swinburnes test cannot be performed on series machines?explain
Difference between shunt, PMG and AREP excitation. Which is the most reliable between PMG and AREP.
raleigh method
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
How we can calculate the life of Lead acid battery
What is depreciation factor?
is it possible to have dc motors on single chip
