Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / satender
you have first of all Start stop the DG's in manual mode ,
then check the voltage biasing and speed biasing by running
it on load ( single unit ) . Then check the phase sequence
of DG's and then give the synchroniizing command
| Is This Answer Correct ? | 2 Yes | 4 No |
Post New Answer View All Answers
THERMAL CAPACITANCE IS MEASURED IN..................................................
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
what shoud be strength and weakness to impress interviewer????????
How many types of faults are there in 3 phase power system?
Can we use 230VAC, 63A MCB for 120VAC, 63A supplied heaters load?
how to calculate mf when meter and cTPT detail are given
sir pls send the je exam - 2008 and other model question papers..
i have been tasked with a design of protection, metering and control(PMC) relay panel extension to accommodate all PMC relays.There is an already existing panel where this one will be built.What are the design aspects for this kind of project? thank you.
What are the reasons for the parallel operation of transformers?
Single line digram for 11 kV to distribution use go,la and do
The specific heats of the gas at constant pressure and constant volume are respectively 1.0 kJ/kg K and 0.72 kJ/kg K; the value of R for the gas is
What is the meaning of dedicated earthing?
I Want randstand placement papers
How to calculate earth wire load by formula
best manufacturer for busbar for outdoor switchyard having double bus bar scheme, can any one share technical specification of busbar. 132kv voltage ?
