Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / mick
it is the cooling method of a transformer
o = oil
n = natural means natural cooled i.e. by a radiator
a = air
f = forced means forced cooled i.e. with a fan
so an ONAN is a naturally cooled oil by natural flow of air
OFAF is oil is force cooled (heat exchanger) and the air is
forced (fans)
| Is This Answer Correct ? | 152 Yes | 9 No |
Post New Answer View All Answers
1.why we are using blocks in withoutgaplightning arrester 2.why we ar using bushing in withoutgap lightning arrestor
why you don not show protection and type of isolation in key single line diagram?
HOW DO YOU CAN CHECK A 15KV DIODE, WHETHER IT IS OK OR NOT?
What is the type of feedback used in an op- amp schmitt trigger?
how to calculate sizing of NGTR (Transformer rating,Loading resistor value and Current rating of resistor) and what is the X/R ratio. Details : 11kV,Capacitance 1.73532 micro farads,40kA for 1sec.
What are steps to be taken while designing of DYN11 distribution transformer to achieve magnetising balance?
Show the schematic arrangement of diesel power station layout and give its principle of operation.
Which motor will you choose which can operate in both lagging as well as leading power factors?
while doing high potential for 11KV 3 core cable how much leakage current will obtain?, what will be acceptance value?
What is electrical grounding?
What is mean by Sensitive Earth fault & what are the effects
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
what is the safety points of vaccum circuit breaker.
Define transfer function?
In a 3 phase 4-wire system. For a 3.5 core cable if all loads are single phase and balanced, what will be neutral current? will it be sum of all phase currents? Or it will be zero? And if loads are unbalanced what will be neutral current?
