Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference between intrinsic instruments and
ATEX instruments?
- 1 Answers
- 6829 Views
- I also Faced
- E-Mail Answers
Answer Posted / vaibhav v t
ATEX means Atmosphere Explosives.ATEX is europiean body for
issuing certification to instruments for thier use in
hazardous area/application.ATEX has specific marking on
instruments which mentions class, div, temp class,gas class.
Instrinsic safe means it is one type achiving safety for
usisng instruments in hazardous application.Electronics in
instruments is designed in a such way that energy generated
during spark inside is such low so tat it will not ignite
explosive gas-air mixture.All componenets are low power
feed.
| Is This Answer Correct ? | 18 Yes | 0 No |
Post New Answer View All Answers
why we should maintain neutral earth voltage below 1V while calibration? why cant it be 1.2V or 2V
How to calibrate an pressure gauge with yantrika test bench?
what is function of SCADA , and how is it work, explain with difination
WHAT IS MEANT BY PROJECT MANAGEMENT STRATEGIES IN INSTRUMENTATION?
What is the diffrence between ff tx and non ff tx
what is cems analyzer explain with principle and drawing ?
How u will setup SPI(2007) on Citrix Server (Thin Client Mode)? Plz Justify?
How can a d.p. Transmitter be calibrated?
defination of radial vibration?
What is the Working principle of Dozing valve?
what is instrument philosophy
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
what are the diff. in servo and regulatory control?
A length of steel pipe is used to carry sea water to a desalination plant. An adequate corrosion allowance must be specified and indicated in the piping specification, which affects the _________________________ of the pipe
