Answer Posted / sam
SCADA is nothing but the HMI,which need to communicate with
the controller and then controler will comunicate with the
field instruments.
DCS(Controller+SCADA) its self have a controller,its
directly commincate to the field instrument.
Is This Answer Correct ? | 11 Yes | 6 No |
Post New Answer View All Answers
Which products are available in the Mass Systemswitch and System Manager AC range?
Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.
How can i test procedure grounding for CAT-7 cable? Or How can we test procedure CAT-7 Cable Electrically safe?
hi,i am doing 3 year in electronic and instrumentation engineering. what type of aptitude questions will be asked in a core industries and how can i improve my skills in instrumentation?
how to check earthing,what is minum ohms for proper earthing
Which Signal hart communicator work? If there any signal change when hart connect while transmitter in line ?
What is zero elevation and zero suppression?
how pressure transmitter work, what is its principal to measure and how its generate signal. for pressure transmitterinstallation which precautions must be taken ??
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
we have level transmitter for h2s04 storage tank capacity 10k ,always there are failure of transmitter due to failure of magnetic floats ,please come up with solutions at the earliest.
you are on site,the plant trips,you are approached by operations,what do you do?
Can anyone send most commonley asked Instrumentation questions and answers in cement industry please?
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
draw shematic diagram of c/v positioner(smart type)?
why orfice is not used for main steam flow calculation