Interested to Buy Any Domain ? << Click Here >> for more details...
What is the reason for low voltage in houses?
- 19 Answers
- 54915 Views
- Maytas, I also Faced
- E-Mail Answers
Answer Posted / abdul wajid
because all the household appliances are designed to
opreate on low voltage and current is directly proportional
to voltage so less voltage means less current
| Is This Answer Correct ? | 1 Yes | 7 No |
Post New Answer View All Answers
What is a surge supressor why its is used in synchronous generators
how to differentiate a mpcb,mcb with a contactor? Explain their working operation
is it possible to test of bus bar in high rise building without completed full floor ?
We are planning to synchronized DG's with our captive plant in the event of black start of plant, but before sync we checked voltage of DG with our plant voltage and it varies from 5 V to 450 V. So in this condition how we can sync DG with plant ?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
What do you mean by dependent and independent voltage sources?
why connecting surge unit in contactor coil
All the socket in a room become very hot, the Wall was also became very hot and the earth conductor also became live, what in your view might be the possible causes?
why does a dc machine has high efficiency while working as a generator than as a motor ..
If oil and air can withstand a high MeV when used as an insulator in a transformer, what are the values of how high for each material?
HOW WE CALCULATE CURRENT IF THERE ARE NOT PRESENT ANY AMMETER OR MULTIMMETER??????
what is basic difference betmeen normal & flame proof motor??
Draw the wave shape of armature current in a generator subjected to a sudden three phase short- circuit at its terminals. Define various reactance of generator from this wave shape.
In Plumbing services What are accessories we consider for a bathroom?
Why cables and busbar both needed in LT Panels?
