Interested to Buy Any Domain ? << Click Here >> for more details...
What is Harmonics & what are its efect & which harmonic is
dangerous
- 5 Answers
- 16329 Views
- IBM, I also Faced
- E-Mail Answers
Answer Posted / abdul wajid
Harmonics is the sudden increase in the system voltage it
is caused by addition of unwanted frequencies to the
sinusiodal waveform of ac system . 3rd harmonics is
dangerous
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
what is the star delta connetion and how can do it a three phase motor with control witing with picture
To prove the capacity of a 10MVA transforemr with 6.5% impedance by a short circuit test how much power is needed to inject an impedance voltage if we have to arrive for its rated current?
which motor have relatively high power factor and what is reason for have high pf? 1.capacitor run motor 2.shaded pole motor 3.capacitor start motor 4.split phase motor
Can we test the alignment of End shield and stator of turbogenerator without rotor insertion? Also how to fix maintain the alignment at site installation?
can u please mail me the syllabus for GET exam for damodar valley corporation?
State the other types of Air Conditioners?
What is the reason for using a GE G101 MCB in place of an EP102 MCB if both are capable of AC circuit protection?
what are the application of over current relay?
what is the value of combined earthing in general electrical circiut?
what curve and rateing would you use for a three phase 0.75kw motor?
does a DG set has low fault level as compared to that of a transformer.If yes then why.
Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632
What fomula is used to calculate: 1. rated frequency withstand voltage, and 2. rated lightning impulse withstand voltage.
HOW DO I CALCULATE THE SETTINGS FOR THE DIFFERENTIAL PROTECTION OF A 12kV/6.6kV, 6MVA,DYN11 XMER WITH PRIMARY SIDE CTR 400/1 AND SEC SIDE CTR 600/1?
what will happen if OLR CT in all phases are short circuted
